“At first glance you would think this machine has more than adequate coolant coverage but

we’ve found SpiderCool to be a huge advantage” said Doug Demars, machinist.

 “This is a very large machine and I have to climb inside the enclosure to adjust the standard coolant lines.  We have 99 tools that can vary in length from 2” to 15” long.  SpiderCool enables me to externally aim, set and remember a separate precise coolant position for every tool in the magazine, regardless of length.  I use the AutoDrill, oscillating cycle, on several tools.

 Bill Morin, Manufacturing Engineer, states; “we are very big on safety at Morgan and having the ability to adjust the coolant, without climbing inside the machine, reduces the potential for injury”.   “Because of the diameter and length of our tools, they are very expensive, already we are seeing an improvement in tool life.” 

 “SpiderCool is easily justified and we intend to install them on additional machines.”

Morgan Construction

Worcester, MA

Bill Morin, Engineer
Doug DeMars, Machinist

Makino MCB 1210 HMC