"When my employer purchased a new Hurco Vertical Machining Center  I was happy with the machine, but disappointed it didn't have a Programmable Coolant Nozzle.  I had seen this option on other machines.  I'm constantly adjusting coolant lines, so I immediately recognized the value.  And for safety reasons, I never reach into the machine while the spindle is running.  I contacted our distributor, who found SpiderCool and had it installed on my machine.  Turns out, SpiderCool is even better than the others I've seen.  It's dead simple to use, and I never have to open the machine door to adjust coolant.  It takes about 2 seconds to aim the coolant exactly where I need it ..... every time.  And if I need to, I can adjust it on the fly.  SpiderCool stores a separate position for each tool in my tool changer, so I can run completely unattended.   I highly recommend SpiderCool to anyone concerned about safety and looking to optimize cycle time.  What a great tool ! " 

 United Tool & Die, Inc.

Wilmington, MA

Ozzie Cormier

1 SpiderCool System

Hurco BMC-2416